Kia Rio: Spark Plug: Cleaning - Ignition System - Engine Electrical System - Kia Rio UB 2012-2026 Service ManualKia Rio: Spark Plug: Cleaning

The combustion temporarily becomes unstable, due to the aged fuel and the carbon deposits accumulated on the spark plug(s) after long-term storage.
[1st Method]
1.
Start the engine and keep the engine running at idle for 2 minutes.
2.
Step on the accelerator pedal and hold it steady at 4500 rpm with the shift lever in N position to warm up  the engine until the temperature of the engine coolant reaches 80°C.
3.
Keep the engine running at 2500~3000 rpm in the N position for 15 minutes.


[2nd Method]

     
The 2nd method should be performed only if the 1st method fails (the misfire-related codes recur).
1.
Start the engine and keep the engine running at idle for 2 minutes.
2.
Drive the vehicle for over 20 minutes, keeping the engine speed above 3500 rpm.

     
If equipped with manual transaxle, shift the gear properly for keeping the engine speed above 3500 rpm.


Spark Plug: Inspection
[On vehicle inspection] 1. Accelerate the engine to about 3,000 rpm 3 times or more. 2. Remove the spark plug. ...

Spark Plug: Removal
1. Remove the ignition coil. (Refer to Ignition System - "Ignition Coil") 2. Using a spark plug wrench, remove the spark plu ...

See also:

Engine Oil: Inspection
1. Check the engine oil quality. Check the oil deterioration, entry of water, discoloring of thinning. If the quality is visibly poor, replace the oil. ...

Using Bluetooth® Wireless Technology
Phone Menu Screen Phone Menus With a Bluetooth® Wireless Technology device connected, press the key to display the Phone menu screen. 1) Favorite : Up to 20 frequently used contacts saved fo ...

Dynamic Damper Installation
1. Apply soap powder on the shaft to prevent being damaged between the shaft spline and the dynamic damper. 2. Install the dynamic damper. ...

Copyright www.kirmanual.com 2014-2026