Kia Rio: Spark Plug: Inspection - Ignition System - Engine Electrical System - Kia Rio UB 2012-2026 Service ManualKia Rio: Spark Plug: Inspection

[On vehicle inspection]
1.
Accelerate the engine to about 3,000 rpm 3 times or more.
2.
Remove the spark plug.
3.
Check the spark plug visually.
If the electrode is dry, the spark plug is normal.
If the electrode is wet, check the damage and electrode gap as below.
[Component Inspection]
1.
Check the spark plug for any damage on its thread and insulator.
If there is damage, replace the spark plug.
2.
Check the electrode. Measure the insulation resistance with an ohmmeter.
If the resistance is less than the specified value, adjust the electrode gap.

Specification: 10 MΩ or more


3.
Check the spark plug electrode gap.
If the gap is greater than the maximum, replace the spark plug.

Specification: 0.9 ~ 1.0 mm (0.0354 ~ 0.0394 in.)


     
If adjusting the gap of a new spark plug, bend only the base of the ground electrode. Do not touch the tip.
Never attempt to adjust the gap on a used plug.


Spark Plug: Specification
Item Specification Type SILZKR6B10E Gap 0.9 ~ 1.0 mm (0.0354 ~ 0.0394 in.) ...

Spark Plug: Cleaning
The combustion temporarily becomes unstable, due to the aged fuel and the carbon deposits accumulated on the spark plug(s) after long-term storage. [1st Method] 1. ...

See also:

Room Lamp Installation
Room Lamp 1. Install the room lamp assembly after connecting the room lamp connector. 2. Install the room lamp lens. ...

Steering Angle Sensor (Except MDPS) Description
The steering angle speed sensor detects the angle of the steering wheel in order to which direction a user chooses.The sensor is detached on the Mutil-Function Switch (MPS) under the steering ...

How to use this manual
We want to help you get the greatest possible driving pleasure from your vehicle. Your Owner’s Manual can assist you in many ways.We strongly recommend that you read the entire manual. In order ...

Copyright www.kirmanual.com 2014-2026