Kia Rio: Specification - Injector - Engine Control System - Engine Control / Fuel System - Kia Rio UB 2012-2026 Service ManualKia Rio: Specification

Item
Specification
Coil Resistance (Ω)
1.5 [20°C(68°F)]

Description
The GDI injector is similar to a standard injector, but sprays fuel at a much higher pressure directly into the combustion chamber and has a swirl disc to get the fuel swirling as it exits th ...

Signal Waveform
The three waveforms below are taken from the #1 and #4 injectors. The top waveform is from the high side (feed side) of the #1 and #4 injectors, while the middle waveform is from the low side ...

See also:

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the connector (A), and then remove the sensor ...

General
1. Basically, all measurements in this manual are taken with a tracking gauge. 2. When a measuring tape is used, check to be sure there is ...

Cluster Ionizer (FATC only) Replacement
1. Disconnect the negative (-) battery terminal. 2. Remove the glove box. (Refer to BD group - "Crash Pad") ...

Copyright www.kirmanual.com 2014-2026