Kia Rio Manuals

Kia Rio: SRS Control Module (SRSCM) Variant coding - SRSCM - Restraint - Kia Rio UB 2012-2026 Service ManualKia Rio: SRS Control Module (SRSCM) Variant coding

After replacing the SRSCM with a new unit, the “Variant Coding” procedure must be performed.

     
1.
On SRSCM variant coding mode, the airbag warning lamp is periodically blinking (ON: 0.5sec., OFF: 0.5sec.) until the coding is normally completed.
2.
If the variant coding is failed, DTC B1762 (ACU Coding Error) will display and the warning lamp will be turned on.
In this case, perform the variant coding procedure again after confirming the cause in “DTC Fault State Information”.
Variant Coding can be performed up to 255 times, but if the number of coding work exceeds 255 times, DTC B1683 (Exceed Maximum coding Number) will be displayed and SRSCM must be replaced.
3.
If the battery voltage is low (less than 9V), DTC B1102 will be displayed. In this case, charge the battery before performing the variant coding procedure.
DTC B1762 (ACU Coding Error) and B1102 (Battery Voltage Low) may be displayed simultaneously.
Variant coding Procedure
■ On-Line type on GDS
1.
With the ignition "OFF", connect GDS.
2.
Ignition "ON" & Engine "OFF" select vehicle name and airbag system.
3.
Select Variant coding mode.
4.
Follow steps on the screen as below.
1) Initial ACU Variant Coding screen


2) VIN Code entering screen


3) Variant coding's proceeding screen-1


4) Variant coding's proceeding screen-2


5) Variant coding is completed



     
1) This screen is opened when you try the variant coding again on the SRSCM that already has the variant coding performed.


2) If communication fails, the following screen will appear.
■ Off-line type on GDS (This can be used when not connecting to internet)
1) Initial ACU Variant Coding screen


2) ACU Coding Code entering screen


3) Screen of rechecking ACU Coding code's entering


4) Variant coding's proceeding screen-1


5) Variant coding's proceeding screen-2


6) Variant coding is completed



     
1) This screen is opened when you try the variant coding again on the SRSCM that already has the variant coding performed.
SRS Control Module (SRSCM) Installation
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes before beginning ...

Front Impact Sensor (FIS) Description
The front impact sensor (FIS) is installed in the front side member. They are remote sensors that detect acceleration due to a collision at its mounting location. The primary purpose of the F ...

See also:

Hood
Opening the hood 1.Pull the release lever to unlatch the hood. The hood should pop open slightly. Open the hood after turning off the engine on a flat surface, shifting the shift lever to the P( ...

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the engine coolant temperature sensor connecto ...

Starter: Inspection
Starter Solenoid Inspection 1. Disconnect the lead wire from the M-terminal of solenoid switch. 2. Connect the battery as shown. If ...

Categories

Copyright www.kirmanual.com 2014-2026