Kia Rio: SS-B Solenoid Valve(ON/OFF) Removal - Automatic Transaxle Control System - Automatic Transaxle System - Kia Rio UB 2012-2026 Service ManualKia Rio: SS-B Solenoid Valve(ON/OFF) Removal

1.
Remove the battery and the battery tray.
(Refer to "Charging system" in EE group.)
2.
Remove the under cover (A).

Tightening torque:
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)


3.
Replace new gasket and the plug after draining the automatic transaxle fluid by removing the drain plug. (Refer to "Hydraulic system (Fluid)" in this group)
4.
Remove the valve body cover (A) and eyebolt (B).

Tightening torque:
13.7 ~ 15.7 N.m (1.4 ~ 1.6 kgf.m, 10.1 ~ 11.6 lb-ft)


     
Always replace the gasket of the eyebolt use new one whenever loosening eyebolt.



     
Remove installation bolts in the engin room first and then remove others under the vehicle.
5.
Remove the bolt (3ea) after disconnecting the solenoid valve connector (B) and the oil temperature sensor connector (A).

Tightening torque:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)


6.
Remove the solenoid valve (B) after removing the solenoid support (A).


SS-B Solenoid Valve(ON/OFF) Inspection
1. Turn ignition switch OFF. 2. Disconnect the solenoid valve connector. 3. Measure resistance between sensor ...

SS-B Solenoid Valve(ON/OFF) Installation
1. Installation is the reverse of removal.    • When installing ...

See also:

A/C Pressure Transducer Description
The A/C Pressure Transducer (APT) convert the pressure value of high pressure line into voltage value after measure it. By converted voltage value, engine ECU controls cooling fan by operatin ...

Water pump: Troubleshooting
Water Pump Symptoms Possible Causes Remedy Coolant leakage • From the bleed hole of the water pump ...

Removal
Rear Disc Brake Type    The parking brake cables must not be bent or distorted. This will lead to stiff operat ...

Copyright www.kirmanual.com 2014-2026