Kia Rio: SS-B Solenoid Valve(ON/OFF) Inspection

1.	Turn ignition switch OFF.

2.	Disconnect the solenoid valve connector.

3.	Measure resistance between sensor signal terminal and sensor ground terminal.

4.	Check that the resistance is within the specification.

SS-B Solenoid Valve(ON/OFF) Circuit Diagram

...

SS-B Solenoid Valve(ON/OFF) Removal

1. Remove the battery and the battery tray. (Refer to "Charging system" in EE group.) 2. Remove the under cover (A). ...

See also:

Multimedia Jack Troubleshooting
Symptom Suspected area Repairment Pressing power switch does not turn on system Radio receiver power source circuit R-1 LCD module R ...

Windshield Wiper-Washer Switch Inspection
Wiper And Washer Switch Inspection With the multifunction switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace ...

Removal
1. Remove the transaxle assembly. (Refer to "Manual transaxle system" in MT group) 2. Remove the clutch cover bolts. Be care ...

Categories

Copyright © www.kirmanual.com 2014-2026