Kia Rio: Starter: Cleaning

1.	Do not immerse parts in cleaning solvent. Immersing the yoke assembly and/or armature will damage the insulation. Wipe these parts with a cloth only.

2.	Do not immerse the drive unit in cleaning solvent. The overrun clutch is pre-lubricated at the factory and solvent will wash lubrication from the clutch.

3.	The drive unit may be cleaned with a brush moistened with cleaning solvent and wiped dry with a cloth.

Starter: Inspection

Starter Solenoid Inspection 1. Disconnect the lead wire from the M-terminal of solenoid switch. 2. Connect the battery as shown. If ...

Cruise Control System

...

See also:

CVVT (Continuously Variable Valve Timing) System: Description
Continuous Variable Valve Timing (CVVT) system advances or retards the valve timing of the intake and exhaust valve in accordance with the ECM control signal which is calculated by the engine ...

Control System Composition
Fault Diagnosis Features a fail-safe mechanism that prevents dangerous situations from developing in the event of a transaxle failure. The limp home mode engages if the transaxle malf ...

Windshield Wiper-Washer Switch Removal
Wiper and Washer Switch 1. Disconnect the negative (-) battery terminal. 2. Remove the steering wheel. (Refer to the ST group - &qu ...

Categories

Copyright © www.kirmanual.com 2014-2026