Kia Rio: TPMS Sensor Removal - Tire Pressure Monitoring System - Suspension System - Kia Rio UB 2012-2026 Service ManualKia Rio: TPMS Sensor Removal


     
Handle the sensor with care.
1.
Remove the tire. (Refer to "Tire Removal")
2.
Remove the valve nut.



     
The valve nut should not be re-used.
3.
Discard the valve assembly.
TPMS Sensor Description
1. Mode (1) Normal Fixed Base State A. Sensor transmissions continue at the Low Line ...

TPMS Sensor Replacement
Repair tire after using the Tire Mobility Kit (TMK) When the TPMS warning lamp OFF 1. Remove the TMK repaired tire, wheel and TPMS sensor. (Refer to ...

See also:

Emergency while driving
If the engine stalls at a crossroad or crossing If the engine stalls at a crossroad or crossing, set the shift lever in the N (Neutral) position and then push the vehicle to a safe place. If you h ...

ECM Problem Inspection Procedure
1. TEST ECM GROUND CIRCUIT: Measure resistance between ECM and chassis ground using the backside of ECM harness connector as ECM side check point. If the problem is fo ...

Fuel Tank Installation
1. Installation is reverse of removal. Fuel tank band installation nut: 39.2 ~ 54.0 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft) ...

Copyright © www.kirmanual.com 2014-2026