Kia Rio Manuals

Kia Rio: TPMS Sensor Replacement - Tire Pressure Monitoring System - Suspension System - Kia Rio UB 2012-2026 Service ManualKia Rio: TPMS Sensor Replacement

Repair tire after using the Tire Mobility Kit (TMK)
When the TPMS warning lamp OFF
1.
Remove the TMK repaired tire, wheel and TPMS sensor.
(Refer to "Tire removal")
2.
Remove the sealant on the wheel and TPMS sensor (A) completely.

     
•
Clean the sealant on the housing and sensing hole of TPMS sensor with clean cloth, gauze or air inhalers.
•
To prevent the sensor and circuit board damage, do not use the pointed instrument and give a lot of impact.


3.
Install the TPMS sensor to the new tire.
4.
Check that the normal operation of TPMS system.
When the TPMS warning lamp ON
1.
Remove the TMK repaired tire, wheel and TPMS sensor.
(Refer to "Tire removal")
2.
Remove the sealant on the wheel and TPMS sensor (A) completely.

     
•
Clean the sealant on the housing and sensing hole of TPMS sensor with clean cloth, gauze or air inhalers.
•
To prevent the sensor and circuit board damage, do not use the pointed instrument and give a lot of impact.


3.
Install the TPMS sensor to the new tire.
4.
Check the tire pressure using the electrical tire pressure gauge.
5.
Check the tire pressure of TPMS sensor using the GDS
6.
If the difference between two checked pressures in the above is not more than 2 psi, TPMS sensor is normal. Reinstall it to new tire.
7.
If the difference between two checked pressures in the above is more than 2 psi, TPMS sensor is abnormal. Install new TPMS sensor to new tire.
8.
Check that the normal operation of TPMS system.
TPMS Sensor Removal
   Handle the sensor with care. 1. Remove the tire. (Refer to "Tire Removal") ...

TPMS Sensor Installation
Sensor Fit    • Handle the sensor with care. • ...

See also:

Head lamp leveling Actuator Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the head lamp assembly (Refer to the head lamp). 3. ...

Rear Washer Switch Inspection
1. With the rear wiper & washer switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace t ...

Starter: Components
1. Screw 2. Front housing 3. Stop ring 4. Stopper 5. Overunn clutch 6. Lever 7. Lever plate 8. Lever packing 9. Magnet switch assembly 10. Armature assemb ...

Categories

Copyright www.kirmanual.com 2014-2026