Kia Rio: Underdrive Brake Control Solenoid Valve(UD/B_VFS) Inspection - Automatic Transaxle Control System - Automatic Transaxle System - Kia Rio UB 2012-2026 Service ManualKia Rio: Underdrive Brake Control Solenoid Valve(UD/B_VFS) Inspection

1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the resistance is within the specification.
Underdrive Brake Control Solenoid Valve(UD/B_VFS) Circuit Diagram
...

Underdrive Brake Control Solenoid Valve(UD/B_VFS) Removal
   Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the ...

See also:

Removal
1. Disconnect the brake fluid level switch connector, and remove the reservoir cap. 2. Remove the brake fluid from the master cylinder res ...

Signal Waveform
...

Installation
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least thirty seconds. ...

Copyright www.kirmanual.com 2014-2026