Using Voice Recognition
Starting Voice Recognition
Shortly press the
key on the steering wheel.
Say a command
If prompt feedback is in [ON], then the system will say “Please say a command after the beep (BEEP)”
Contact List Best Practices
1)Do not store single-name entries (e.g., “Bob”, “Mom”, “Kim”, etc.). Instead, always use full names (including first and last names) for all contacts (e.g., use “Jacob Stevenson” instead of “Dad”).
2)Do not use abbreviations (i.e., use “Lieutenant” instead of “Lt.” or “Sergeant” instead of “Sgt.”).
3)Do not use acronyms (i.e., use “County Finance Department” instead of “CFD”).
4)Do not use special characters (e.g., “@”, “hyphen -“, “asterisk *”, ampersand &”).
5)If a name is not recognized from the contact list, change it to a more descriptive name (e.g., use “Grandpa Joseph” instead of “Pa Joe”).
Skipping Prompt Messages
While prompt message is being stated
Shortly press
the key on
the steering remote controller (under 0.8 seconds)
The prompt message is immediately ended and the beep tone will sound. After the “beep”, say the voice command.
Re-starting Voice Recognition
While system waits for a command
Shortly press the
key on the
steering remote controller (under 0.8 seconds)
The command wait state is immediately ended and the beep tone will sound. After the “beep”, say the voice command.
Dimensions Projected
1.
These are the dimensions measured when the measurement points
are projected from the vehicle's surface, and are the reference dimensions
used for used for body ...
Tightening Torque
Items
N.m
kgf.m
lb-ft
Front and rear doors
Door hinge to body
34.3 ~ 41.2
3.5 ~ 4.2
25.3 ~ 30.4
Door hinge to door
...
Specifications
Items
Specifications
Rated voltage
DC 5V
Load
Max. 1.5mA (When head lamp lighting)
Operating voltage range
DC 4.6 ~ 5.1V
...