1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the crash pad lower panel.
(Refer to the BD group - "Crash pad")
|
3. |
Disconnect the 6P connector (B) after loosening the screw and
then remove the antenna coil (A).
|
Shift Lever Adjustment
1.
In neutral position, disjoin select cable (A) from shift lever
assembly pin (B).
2.
Disconnect select adjuster (A) to an arrow.
...
Line Pressure Control Solenoid Valve Specifications
Direct control VFS[LINE Pressure]
▷ Control type : Normal low type
Control Pressure kpa (kgf/cm², psi)
500.14 ~ 9.81 (5.1 ~ 0.1,72.54 ~ 1.42)
Current ...
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the PCSV connector.
3.
Measure resistance between the PCSV termi ...