Kia Rio: Cluster Ionizer (FATC only) Description

The cluster ionizer helps to clean up odors in the vehicle or from the air-conditioner system.

When the ignition switch ON, the inoizer runs a "CLEAN" mode and then a "ION" mode, switching every about 15 minutes.

In the “CLEAN” mode, the cluster ionizer generates negative and positive ions to help clean smells from the air

In the "ION" mode, the cluster generates negative ions and cleans inside air of a vehicle.

Auto Defogging Sensor (FATC only) Replacement

1. Remove the auto defogging sensor cover (A). 2. Disconnect the connector (B) and then remove the auto defogging sensor (C). ...

Cluster Ionizer (FATC only) Inspection

1. Press the MODE switch more then 4 times within 2 seconds while pressing the OFF switch. Display Fail description 00 ...

See also:

BCM connectors
Pin No. Connector A Connector B Connector C 1 Battery (+) K_LINE Turn signal switch (RH) 2 Ignition 2 Centr ...

Inspection
Lighting Switch Inspection With the multifunction switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the mul ...

Steering Angle Sensor (MDPS Only) Description
The Steering Angle Sensor (SAS) is installed in MDPS (Motor Driven Power Steering) and it sends messages to HECU through CAN communication line. The SAS is used to determine turning directio ...