Kia Rio: Inspection - Variable Intake Solenoid (VIS) Valve - Engine Control System - Engine Control / Fuel System - Kia Rio UB 2012-2019 Service ManualKia Rio: Inspection

1.
Turn the ignition switch OFF.
2.
Disconnect the VIS valve connector.
3.
Measure resistance between VIS valve terminals 1 and 2.

Specification: Refer to "Specification"

Circuit Diagram
(M/T) (A/T) ...

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the variable intake solenoid valve connector ( ...

See also:

Intake Actuator Description
The intake actuator is located at the blower unit. It regulates the intake door by signal from control unit. Pressing the intake selection switch will shift between recirculation and fresh ai ...

Weight Classification System (WCS) Removal
1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work. 2. Remove the front passenger seat ass ...

Measuring Body Dimensions
1. Basically, all measurements in this manual are taken with a tracking gauge. 2. When a measuring tape is used, check to be sure there is ...

Copyright © www.kirmanual.com 2014-2019