Kia Rio Manuals

Kia Rio: Removal - Multifunction switch - Body Electrical System - Kia Rio UB 2012-2026 Service ManualKia Rio: Removal

Wiper and Washer Switch
1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering wheel.
(Refer to the ST group - "Steering column & shaft")
3.
Remove the steering column upper (A) and lower (B) shrouds after removing the screw.
4.
Disconnect the connector(A). Release the lock of wiper switch using tool without removing the steering wheel and the clock spring.
Remove the wiper and washer switch.
Multifunction Switch Assembly
1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering wheel.
(Refer to the ST group - "Steering column & shaft")
3.
Remove the steering column upper and lower shrouds after removing 3 screws.
4.
Remove the clock spring.
(Refer to the RT group - "Airbag module")
5.
Disconnect the lighting switch connector and wiper & washer switch connector.
Remove the multifunction switch assembly (A) after loosening 2 mounting screws.
Inspection
Lighting Switch Inspection With the multifunction switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the mul ...

Installation
Multifunction Switch 1. Install the multifunction switch. 2. Install the clock spring. 3. Install the steer ...

See also:

Manual transaxle
Manual transaxle operation The manual transaxle has 6 forward gears. This shift pattern is imprinted on the shift knob. The transaxle is fully synchronized in all forward gears so shifting to ei ...

Power Out Side Mirror Switch Inspection
1. Disconnect the negative (-) battery terminal. 2. Remove the front door trim panel. (Refer to the BD group - "Front door") ...

Component Location
1. Instrument cluster assembly 2. Seat belt switch 3. Vehicle speed sensor 4. Engine coolant temperature sender 5. Oil pressure switch 6. Brake fluid level warning switch ...

Categories

Copyright www.kirmanual.com 2014-2026