Kia Rio: Removal

Inspection

Horn Inspection Test the horn by connecting battery voltage to the 2 terminal and ground the 1 terminal. 1 : 12V Ground(-) 2 : 12V (+)    ...

Installation

1. Connect the horn connector, then reassemble the horn. ...

See also:

Inspection
1. Check signal waveform of CKPS and CMPS using a GDS. Specification: Refer to “Waveform� ...

Engine coolant
The high-pressure cooling system has a reservoir filled with year-round antifreeze coolant. The reservoir is filled at the factory. Check the antifreeze protection and coolant level at least once a ...

TJ Joint Components
[LH] 1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot 5. Shaft 6. TJ boot band 7. TJ boot 8. Spider assembly 9. Snap ring 10. TJ c ...