Kia Rio: Seat Heater Inspection

Driver seat and Passenger seat

1.

Check for continuity and measure the resistance between terminals.

[Cushion]

Pin No.	Description	Pin No.	Description
1	Heater(-)	4	NTC -
2	Heater(+)	5	NTC +

Average Max. temperature

- Cushion : HIGH : 42 Â± 2Â°C / LOW : 39 Â± 2Â°C

- Back : HIGH : 52 Â± 2Â°C / LOW : 46 Â± 2Â°C

2.

Operate the seat heater after connecting the connector, and then check the thermostat by measuring the temperature of seat surface.

Standard value (Fabric / Leather)

- Cushion : 1.18Ω Â± 10%

- Back : 1.13Ω Â± 10%

- Set : 2.31Ω Â± 10%

Seat Heater Components

...

Seat Heater Switch Schematic Diagram

...

See also:

Overhead Console Lamp Installation
1. Install the overhead console lamp after connecting the sunroof switch connector and lamp connector. 2. Install the lens after tightening ...

Condenser Inspection
1. Check the condenser fins for clogging and damage. If clogged, clean them with water, and blow them with compressed air. If bent, gently bend them using a screwdrive ...

SRS Control Module (SRSCM) Removal
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes before beginning ...

Categories

Copyright © www.kirmanual.com 2014-2026