Kia Rio Manuals

Kia Rio: Troubleshooting - Indicators And Gauges - Body Electrical System - Kia Rio UB 2012-2026 Service ManualKia Rio: Troubleshooting

Symptom
 Possible cause
 Remedy
Speedometer does not operate
 Cluster fuse (10A) is blown
 Check for short and replace fuse
Speedometer faulty
 Check speedometer
Vehicle speed sensor faulty
 Check vehicle speed sensor
Wiring or ground faulty
 Repair if necessary
Tachometer does not operate
 Cluster fuse (10A) is blown
 Check for short and replace fuse
Tachometer faulty
 Check tachometer
Wiring or ground faulty
 Repair if necessary
Fuel gauge does not operate
 Cluster fuse (10A) is blown
 Check for short and replace fuse
Fuel gauge faulty
 Check gauge
Fuel sender faulty
 Check fuel sender
Wiring or ground faulty
 Repair if necessary
Low fuel warning lamp does not light up
 Cluster fuse (10A) is blown
 Check for short and replace fuse
LED burned out
 Replace cluster
Fuel sender faulty
 Check fuel sender
Wiring or ground faulty
 Repair if necessary
Water temperature gauge does not operate
 Cluster fuse (10A) is blown
 Check for short and replace fuse
Water temperature gauge faulty
 Check gauge
Water temperature sender faulty
 Check sender
Oil pressure warning lamp does not light up
 Cluster fuse (10A) is blown
 Check for short and replace fuse
Bulb burned out
 Replace bulb
Oil pressure switch faulty
 Check switch
Wiring or ground faulty
 Repair if necessary
Parking brake warning lamp does not light up
 Cluster fuse (10A) is blown
 Check for short and replace fuse
LED burned out
 Replace cluster
Brake fluid level warning switch faulty
 Check switch
Parking brake switch faulty
 Check switch
Wiring or ground faulty
 Repair if necessary
Open door warning lamp and trunk lid warning lamp do not light up
 Room lamp fuse (10A) is blown
 Check for short and replace fuse
LED burned out
 Replace cluster
Door switch faulty
 Check switch
Wiring or ground faulty
 Repair if necessary
Seat belt warning lamp does not light up
 Cluster fuse (10A) is blown
 Check for short and replace fuse
LED burned out
 Replace cluster
Seat belt switch faulty
 Check switch
Wiring or ground faulty
 Repair if necessary

Instrument Cluster Installation
1. Connect the cluster connector. 2. Install the cluster assembly. 3. Install the center fascia panel. ...

Power Door Locks
...

See also:

Cleaning
1. Make sure the ignition switch and all accessories are in the OFF position. 2. Disconnect the battery cables (negative first). ...

Removal
Wiper and Washer Switch 1. Disconnect the negative (-) battery terminal. 2. Remove the steering wheel. (Refer to the ST group - &qu ...

Component Location
1. Tailgate actuator & switch 2. Rear door switch 3. Body control module 4. Key warning switch 5. Front door switch 6. Front door lock actuator & switch 7. Rear do ...

Categories

Copyright www.kirmanual.com 2014-2026