Kia Rio: Windshield Wiper-Washer Switch Inspection

Wiper And Washer Switch Inspection

With the multifunction switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the multi-function switch.

Wiper Switch (Intermittent)

Washer Switch

Rear wiper switch

Rear washer switch

Component Location

1. Windshield wiper arm & blade 2. Wiper & washer switch 3. Windshield washer hose 4. Windshield wiper motor & linkage 5. Washer motor 6. Washer reservoir ...

Windshield Wiper-Washer Switch Removal

Wiper and Washer Switch 1. Disconnect the negative (-) battery terminal. 2. Remove the steering wheel. (Refer to the ST group - &qu ...

See also:

Rear Wiper Motor Installation
1. Install the rubber packing. 2. Install the rear wiper motor assembly. Tightening torque : 6.86 ~ 9.81N ...

Output Speed Sensor Installation
1. Installation is the reverse of removal.    After replacement or reinstallation procedure of ...

TJ Joint Installation
1. Wrap tape around the driveshaft spline(TJ) to prevent damage to the boot. 2. Using the alignment marks (D) made during disassembly as a ...