Kia Rio: Rear Wiper Motor Inspection
Rear Wiper Motor
| 1. |
Remove the 4P connector from the rear wiper motor.
|
| 2. |
Connect battery positive (+) and negative (-) cables to terminals
4 and 1 respectively.
|
| 3. |
Check that the motor operates normally. Replace the motor if it
operates abnormally.
|
Automatic Stop Operation Check
| 1. |
Operate the motor at low speed using the stalk control.
|
| 2. |
Stop the motor operation anywhere except at the off position by
disconnecting terminal 3.
|
| 3. |
Connect terminals 2 and 3.
|
| 4. |
Connect the positive (+) lead from the battery to terminal 1 and
the negative (-) lead to terminal 4.
|
| 5. |
Check that the motor stops running at the off position.
|
Rear Wiper Motor Installation
1.
Install the rubber packing.
2.
Install the rear wiper motor assembly.
Tightening torque :
6.86 ~ 9.81N ...
Rear Washer Switch Inspection
1.
With the rear wiper & washer switch in each position, make sure
that continuity exists between the terminals below. If continuity is
not as specified, replace t ...
See also:
Transaxle Oil Temperature Sensor Description
Transaxle oil temperature sensor monitors the automatic transaxle fluid's
temperature and conveys the readings to TCM. It is an NTC (Negative Thermal
Coefficient) sensor whose resistance ...
Seat Belt Buckle Switch (BS) Description
The SRSCM shall monitor the status of the driver and front passenger seat
belt buckle. The SRSCM provides one pin each for the driver and front passenger
seat belt buckle status input. The se ...
ESC Operation Mode
ESC Hydraulic System Diagram
1.
ESC Non-operation : Normal braking.
Solenoid valve
Continuity
Valve
Motor ...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2026 Owners Manual
- Kia Rio YB 2017-2026 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2026