Kia Rio: Head lamp leveling Actuator Removal - Head lamp leveling Device - Body Electrical System - Kia Rio UB 2012-2026 Service ManualKia Rio: Head lamp leveling Actuator Removal

1.
Disconnect the negative (-) battery terminal.
2.
Remove the head lamp assembly (Refer to the head lamp).
3.
Remove the head lamp leveling actuator by turning the adjusting gear in the hole using the adjusting wheel or screw driver.
Circuit Diagram
...

Head lamp leveling Actuator Installation
1. Install the head lamp leveling actuator by turning the adjusting gear. 2. Install the head lamp assembly. 3. ...

See also:

Audio system
If you install an aftermarket HID head lamp, your vehicle’s audio and electronic device may malfunction. Antenna Your vehicle uses a roof antenna to receive both AM and FM broadcast signals. ...

Mode Control Actuator Description
The mode control actuator is located at the heater unit. It adjusts position of mode door by operating mode control actuator based on signal of A/C control unit. Pressing mode select switch ...

Components Location
1. Purge control solenoid valve (PCSV) 2. Vapor line 3. ORVR valve 4. Fuel tank air filter 5. Canister close valve (CCV) 6. Canister 7. Fuel tank pressure sensor ( ...

Copyright www.kirmanual.com 2014-2026