Kia Rio: Auto Defogging Sensor (FATC only) Description

The Auto Defogging Sensor is installed on the front windshild glass. The Auto Defogging Sensor senses moisture on the windshild. The air conditioner control module receives the signal from the sensor and eliminates fog by controlling the intake actuator, A/C, auto defogging actuator, blower motor rpm, and mode actuator.

Ambient Temperature Sensor Replacement

1. Disconnect the negative (-) battery terminal. 2. Remove the engine room RH side under cover. (Refer to EM group - “Engine and Trans ...

Auto Defogging Sensor (FATC only) Inspection

1. Press the MODE switch more then 4 times within 2 seconds while pressing the OFF switch. Display Fail description 00 ...

See also:

Circuit Diagram
(M/T) (A/T) ...

26 Brake Control Solenoid Valve(26/B_VFS) Removal
   Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the ...

Mode Control Actuator Description
The mode control actuator is located at the heater unit. It adjusts position of mode door by operating mode control actuator based on signal of A/C control unit. Pressing mode select switch ...