Kia Rio: Temperature Control Actuator Replacement
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the driver side shower duct (A) after loosening the screw.
|
| 3. |
Disconnect the connector (A) and then remove the temperature control
actuator (B) after loosening the mounting screws.
|
| 4. |
Install in the reverse order of removal.
|
Temperature Control Actuator Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the temperature control actuator connector.
3.
Verify that the t ...
Mode Control Actuator Description
The mode control actuator is located at the heater unit.
It adjusts position of mode door by operating mode control actuator based
on signal of A/C control unit. Pressing mode select switch ...
See also:
Fuel requirements
Your new Kia vehicle is designed to use only unleaded fuel having a pump octane
number ((R+M)/2) of 87 (Research Octane Number 91) or higher.
Your new vehicle is designed to obtain maximum performa ...
Transaxle Control Module (TCM) Terminal Function
Connector [EGGG-AA]
Pin
Description
Pin
Description
22
Shift solenoid D (VFS-OD)
73
Inhibitor switch signal "S4"
...
Driver Airbag (DAB) Module and Clock Spring Inspection
Driver Airbag (DAB)
If any improper parts are found during the following inspection, replace
the airbag module with a new one.
...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2026 Owners Manual
- Kia Rio YB 2017-2026 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2026