Kia Rio: Mode Control Actuator Inspection
| 1. |
Turn the ignition switch OFF.
|
| 2. |
Disconnect the mode control actuator connector.
|
| 3. |
Verify that the mode control actuator operates to the defog mode
when connecting 12V to terminal 4 and grounding terminal 3.
Verify that the mode control actuator operates to the vent mode
when connecting in the reverse.
|
| 4. |
Connect the mode control actuator connector.
|
| 5. |
Turn the ignition switch ON.
|
| 6. |
Check the voltage between terminal 6 and 7.
Specification
With auto defogging activated
With auto defogging deactivated
It will feedback current position of actuator to controls.
|
| 7. |
If the measured voltage is not within specification, substitute
with a known-good mode control actuator and check for proper operation.
|
| 8. |
Replace the mode control actuator if it is proved that there is
a problem with it.
|
Mode Control Actuator Description
The mode control actuator is located at the heater unit.
It adjusts position of mode door by operating mode control actuator based
on signal of A/C control unit. Pressing mode select switch ...
Mode Control Actuator Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad.
(Refer to BD group - "Crash Pad")
...
See also:
Ignition Switch Assembly Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering column upper and lower shrouds.
(Refer to the ST group - & ...
Power Mosfet (FATC) Inspection
1.
Turn the ignition switch ON.
2.
Manually operate the control switch and measure the voltage of
blower motor.
3.
...
Component Location
1. Sunroof
2. Sunroof switch
3. Sunroof motor & controller
...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2026 Owners Manual
- Kia Rio YB 2017-2026 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2026