Kia Rio: Mode Control Actuator Replacement
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the crash pad.
(Refer to BD group - "Crash Pad")
|
| 3. |
Remove the BCM unit.
(Refer to BE group - "BCM")
|
| 4. |
Disconnect the connector (A) and then remove the mode control
actuator (B) after loosening the mounting screws.
|
| 5. |
Install in the reverse order of removal.
|
Mode Control Actuator Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the mode control actuator connector.
3.
Verify that the mode con ...
Foot Actuator (With Auto Defogging System) Description
The foot actuator is located at the heater unit. It adjusts position of
the foot door in heater unit of the vehicle equipped with the auto defogging
system. ...
See also:
TJ Joint Installation
1.
Wrap tape around the driveshaft spline(TJ) to prevent damage to
the boot.
2.
Using the alignment marks (D) made during disassembly as a ...
Power Window Switch Circuit Diagram
Driver Power Window Switch
Passenger Power Window Switch
Rear Power Window Switch
...
Fuel Filler Cap
Description
A ratchet tightening device on the threaded fuel filler cap reduces the
chances of incorrect installation, which seals the fuel filler. After the gasket
on the fuel filler cap an ...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2026 Owners Manual
- Kia Rio YB 2017-2026 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2026