Kia Rio: Adjustment
| Battery Sensor Recalibration Procedure
|
If disconnecting the negative (-) battery cable from the battery during
repair work for the vehicle equipped with Alternator Managing System(AMS) function,
Battery sensor recalibration procedure should be performed after finishing
the repair work.
|
1. |
Turn the Iginition switch ON and OFF.
|
|
2. |
Park the vehicle about 4 hours under below states.
| A. |
Park the vehicle about 4 hours under below states.
|
| B. |
Closing the hood, trunk, and all doors.
|
|
|
3. |
After 4 hours later, check whether the current datas are displayed
normally or not using GDS.
| A. |
Nominal capacity(AMS) = 45Ah [For Non-ISG type]
|
| B. |
Nominal capacity(AMS) = 60Ah [For ISG type or Russia region]
|
| C. |
State of Charge of Battery(AMS) = (0~100%)
|
| D. |
State of Health of Battery(AMS) = (0~100%)
|
|
|
4. |
After cranking the engine 2 times or more, check "State of Function
of Battery(AMS) =(0~12V)". [For ISG system only]
|
1.
Check for DTCs.
•
If a DTC ...
See also:
Steering Gear box Components
1. Tie-rod end
2. Lock nut
3. Bellows clip
4. Bellows
5. Tie rod
6. Rack bar
7. Dust packing
8. Dust cap
9. Oil seal
10. Pinion plug
11. Pinion assembl ...
Refrigeration Cycle
...
Overhead Console Lamp Inspection
Remove the overhead console lamp assembly then check for continuity between
terminals. If the continuity is not as specified, replace the overhead console
lamp assembly.
...
Inspection
Starting System