Kia Rio Manuals

Kia Rio: Cruise Control Switch: Inspection - Cruise Control System - Engine Electrical System - Kia Rio UB 2012-2026 Service ManualKia Rio: Cruise Control Switch: Inspection

Measuring Resistance
1.
Disconnect the cruise control switch connector from the control switch.
2.
Measure resistance between terminals on the control switch when each function switch is ON (switch is depressed).
Function switch
 Terminal
 Resistance
CANCEL
 3 - 4
 180 Ω ± 5%
SET/–
 3 - 4
 330Ω ± 5%
RES/+
 3 - 4
 550Ω ± 5%
ON/OFF
 3 - 4
 880Ω ± 5%
SLD
 3 - 4
 1.44kΩ ± 5%

3.
If not within specification, replace switch.
Measuring Voltage
1.
Connect the cruise control switch connector to the control switch.
2.
Measure voltage between terminals on the harness side connector when each function switch is ON (switch is depressed).
Function switch
 Terminal
 Voltage
CANCEL
 3 - 4
 0.76 ± 0.1V
SET/–
 3 - 4
 1.24 ± 0.15V
RES/+
 3 - 4
 1.77 ± 0.2V
ON/OFF
 3 - 4
 2.34 ± 0.1V
SLD
 3 - 4
 3.0 ± 0.22V

3.
If not within specification, inspect the control switch resistance.
The measuring resistance value is not within specification, replace the switch and measure the voltage again.
4.
If resistance is OK but, measuring voltage is not within specification, inspect the wiring harness and connectors between the switch and the ECM.`
Cruise Control Switch: Installation
1. Install in the reverse order of removal. ...

Emission Control System
...

See also:

ESC OFF Switch Inspection
1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the crash pad lower panel. (Refer to the Body ...

Transaxle Oil Temperature Sensor Circuit Diagram
...

Components
1. Reservoir cap 2. Reservoir 3. Grommet 4. Master cylinder assembly ...

Categories

Copyright www.kirmanual.com 2014-2026