Kia Rio: Installation

When replacing the ECM, the vehicle equipped with immobilizer must be performed the procedure as below.

[In the case of installing used ECM]

1.	Perform "Neutral mode" procedure with GDS. (Refer to "Immobilizer" in BE group)

2.	Insert the key and turn it to the IGN ON and OFF position.

Then the ECM key register process is completed automatically.

[In the case of installing new ECM]

-	Insert the key and turn it to the IGN ON and OFF position.

Then the ECM key register process is completed automatically.

Installation is reverse of removal.

ECM installation bolt:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

ECM bracket installation bolt:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Removal

When replacing the ECM, the vehicle equipped with immobilizer must be performed the procedure as below. ...

ECM Problem Inspection Procedure

1. TEST ECM GROUND CIRCUIT: Measure resistance between ECM and chassis ground using the backside of ECM harness connector as ECM side check point. If the problem is fo ...

Kia Rio: Installation

Removal

ECM Problem Inspection Procedure

See also:

Categories