Kia Rio: Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Disconnect the manifold absolute pressure sensor connector (A).
|
| 3. |
Remove the installation bolt (B), and then remove the sensor from
the surge tank.
|
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the MAPS at idle and IG ON.
Spe ...
Installation
•
Install the component with the specified torques.
•
...
See also:
Description
Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures
the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor
element) built in the sensor ...
Troubleshooting
Vehicle inspection
SYMPTOM CHART
Symptom
Suspect Area
Remedy (See page)
Squeak or grunt-noise from the front suspension, occurs more
in cold ambient t ...
Specifications
Item
Specification
Rated voltage
DC 3V
Service voltage range
DC 2.7V ~ 3.5V
Temperature range
-4°F ~ 140°F (-20°C ~ +60°C) ...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2026 Owners Manual
- Kia Rio YB 2017-2026 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2026