Kia Rio: Waveform

This example shows a typical Crankshaft Position Sensor(CkPS) and Camshaft Position Sensor(CMPS) waveform at idle.The PCM controls the injection and ignition timing by using these signals.

Generally CkPS signal is used to detect the piston's position and CMPS signal is used to detect the Top Dead Center of each cylinder.

Specification

Item Specification Coil Resistance (Ω) 774 ~ 946 [20°C (68°F)] ...

Circuit Diagram

(M/T) (A/T) ...

See also:

Component Location
1. Instrument cluster assembly 2. Seat belt switch 3. Vehicle speed sensor 4. Engine coolant temperature sender 5. Oil pressure switch 6. Brake fluid level warning switch ...

Wipers & Washers
A : Wiper speed control (front) HI – High wiper speed LO – Low wiper speed INT – Intermittent wipe AUTO– Automatic control wipe OFF – Off MIST – Single wipe B : Intermit ...

Driving your vehicle
Be sure the exhaust system does not leak. The exhaust system should be checked whenever the vehicle is raised to change the oil or for any other purpose. If you hear a change in the sound of the ex ...