Kia Rio: Inspection - Injector - Engine Control System - Engine Control / Fuel System - Kia Rio UB 2012-2026 Service ManualKia Rio: Inspection

1.
Turn the ignition switch OFF.
2.
Disconnect the injector connector.
3.
Measure resistance between the injector terminals 1 and 2.
4.
Check that the resistance is within the specification.

Specification: Refer to “Specification”

Circuit Diagram
(M/T) (A/T) ...

Removal
   In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be inju ...

See also:

Temperature Control Actuator Replacement
1. Disconnect the negative (-) battery terminal. 2. Remove the driver side shower duct (A) after loosening the screw. ...

Multimedia Jack Troubleshooting
Symptom Suspected area Repairment Pressing power switch does not turn on system Radio receiver power source circuit R-1 LCD module R ...

Room Lamp Inspection
Room Lamp Remove the room lamp assembly then check for continuity between terminal. If the continuity is not as specified, replace the room lamp assemlby. ...

Copyright www.kirmanual.com 2014-2026