Kia Rio: Fuel Tank Removal - Fuel Delivery System - Engine Control / Fuel System - Kia Rio UB 2012-2026 Service ManualKia Rio: Fuel Tank Removal

1.
Release the residual pressure in fuel line (Refer to the Fuel Delivery System - Repair Procedures - "Release Residual Pressure in Fuel Line").
2.
Remove the rear seat [LH] (Refer to “Seat” in BD group).
3.
Remove the fuel pump service cover (A).


4.
Disconnect the fuel pump connector (A).
5.
Disconnect the fuel feed tube quick connector (B).
6.
Disconnect the fuel tank pressure sensor connector (C).
7.
Disconnect the vapor tube (D).


8.
Lift the vehicle and support the fuel tank with a jack.
9.
Remove the center muffler assembly (Refer to “Intake And Exhaust System” in EM group).
10.
Disconnect the fuel filler hose (A) and the vapor hose (B).


11.
Remove the parking brake line installation bolt (A).


12.
Remove the fuel tank from the vehicle after removing the fuel tank band (A).


Release Residual Pressure in Fuel Line
   Whenever the high pressure fuel pump, fuel pipe, delivery pipe, or injector is removed immediately after shutting off th ...

Fuel Tank Installation
1. Installation is reverse of removal. Fuel tank band installation nut: 39.2 ~ 54.0 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft) ...

See also:

Front Hub / Knuckle Replacement
1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) fro ...

Windshield Wiper-Washer Switch Removal
Wiper and Washer Switch 1. Disconnect the negative (-) battery terminal. 2. Remove the steering wheel. (Refer to the ST group - &qu ...

Starter: Removal and Installation
1. Disconnect the battery negative terminal. 2. Remove the air duct and air cleaner assembly. (Refer to EM group) 3. ...

Copyright www.kirmanual.com 2014-2026