Kia Rio Manuals

Kia Rio: Transaxle Oil Temperature Sensor Removal - Automatic Transaxle Control System - Automatic Transaxle System - Kia Rio UB 2012-2026 Service ManualKia Rio: Transaxle Oil Temperature Sensor Removal

1.
Remove the battery and the battery tray.
(Refer to "Charging system" in EE group.)
2.
Remove the under cover (A).
Tightening torque:
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft) )


3.
Replace new gasket and the plug after draining the automatic transaxle fluid by removing the drain plug. (Refer to "Hydraulic system (Fluid)" in this group)
4.
Remove the air breather hose (A).
5.
Remove the valve body cover (B).
Tightening torque:
13.7 ~ 15.7 N.m (1.4 ~ 1.6 kgf.m, 10.8 ~ 11.6 lb-ft)


6.
Disconnect the oil temperature sensor connector (A).
7.
Remove the oil temperature sensor (A) after removing a bolt.
Tightening torque:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)


Transaxle Oil Temperature Sensor Inspection
1. Turn ignition switch OFF. 2. Disconnect the solenoid valve connector. 3. Measure resistance between sensor ...

Transaxle Oil Temperature Sensor Installation
1. Installation is the reverse of removal.    After replacement or reinstallation procedure of ...

See also:

Smart key unit Component
...

Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Specifications
Direct control VFS[35R/C] ▷ Control type : Normal low type Control Pressure kpa (kgf/cm², psi) 500.14 ~ 9.81 (5.1 ~ 0.1,72.54 ~ 1.42) Current value(mA ...

Specification
Item Specification Coil Resistance (Ω) 6.9 ~ 7.9 [20°C(68°F)] ...

Categories

Copyright www.kirmanual.com 2014-2026