Kia Rio: Torque Converter Control Solenoid Valve (T/CON_VFS) Inspection
| 1. |
Turn ignition switch OFF.
|
| 2. |
Disconnect the solenoid valve connector.
|
| 3. |
Measure resistance between sensor signal terminal and sensor ground
terminal.
|
| 4. |
Check that the resistance is within the specification.
|
Torque Converter Control Solenoid Valve (T/CON_VFS) Removal
1.
Remove the battery and the battery tray.
(Refer to "Charging system" in EE group.)
2.
Remove the under cover (A).
...
See also:
Components
1. Battery (Non-ISG Type)
2. Battery (ISG Type)
3. Battery tray
4. Battery insulation pad
5. Battery mounting bracket
...
Installation
•
Install the component with the specified torques.
•
...
Receiver-Drier Replacement
1.
Remove the condenser.
2.
Remove the cap (B) on the bottom of the condenser with L wrench
(A).
Tightening torq ...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2026 Owners Manual
- Kia Rio YB 2017-2026 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2026