Kia Rio: Line Pressure Control Solenoid Valve Inspection - Automatic Transaxle Control System - Automatic Transaxle System - Kia Rio UB 2012-2025 Service ManualKia Rio: Line Pressure Control Solenoid Valve Inspection

1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the resistance is within the specification.
Line Pressure Control Solenoid Valve Circuit Diagram
...

Line Pressure Control Solenoid Valve Removal
   Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the ...

See also:

Inspection
Lighting Switch Inspection With the multifunction switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the mul ...

ESC Control Module Removal
1. Turn ignition switch OFF. 2. Pull up the lock of the HECU connector (A), and then disconnect the connector. ...

Component Location Index
Engine Room 1. Receiver Drier 2. Condenser 3. Ambient Temperature Sensor 4. Compressor 5. Discharge Hose 6. Suction & Liquid Tube Assembly 7. Service ...

Copyright www.kirmanual.com 2014-2025