Kia Rio: SS-B Solenoid Valve(ON/OFF) Inspection

1.	Turn ignition switch OFF.

2.	Disconnect the solenoid valve connector.

3.	Measure resistance between sensor signal terminal and sensor ground terminal.

4.	Check that the resistance is within the specification.

SS-B Solenoid Valve(ON/OFF) Circuit Diagram

...

SS-B Solenoid Valve(ON/OFF) Removal

1. Remove the battery and the battery tray. (Refer to "Charging system" in EE group.) 2. Remove the under cover (A). ...

See also:

Components
1. Union bolt 2. Gasket 3. Tube joint 4. Clutch tube 5. Valve plate 6. Valve spring 7. Bleeder screw 8. Release cylinder 9. Return spring 10. Piston 11 ...

Compressor Oil Specification
1. The HFC-134a system requires synthetic compressor oil (PAG) whereas the R-12 system requires mineral compressor oil. The two oils must never be mixed. ...

Auto Defogging Sensor (FATC only) Replacement
1. Remove the auto defogging sensor cover (A). 2. Disconnect the connector (B) and then remove the auto defogging sensor (C). ...

Categories

Copyright © www.kirmanual.com 2014-2026