Kia Rio Manuals

Kia Rio: Dynamic Damper Replacement - Driveshaft Assembly - Driveshaft and axle - Kia Rio UB 2012-2026 Service ManualKia Rio: Dynamic Damper Replacement

1.
Remove the front driveshaft. (Refer to DS group - “Front Driveshaft”)
2.
Remove the TJ joint assembly. (Refer to DS group - “TJ joint”)
3.
Remove the remove the both side of band (B) of the dynamic damper (A).
4.
Fix the driveshaft (A) with a vice (B) as illustrated.
5.
Apply soap powder on the shaft to prevent being damaged between the shaft spline and the dynamic damper when the dynamic damper is removed.
6.
Seperate the dynamic damper (A) from the shaft (B) carefully.
Dynamic Damper Components
1. BJ assembly 2. Circlip 3. BJ boot band 4. BJ boot 5. Dynamic damper band 6. Dynamic damper 7. Shaft 8. TJ boot band 9. TJ boot 10. Spider assembly 1 ...

Dynamic Damper Installation
1. Apply soap powder on the shaft to prevent being damaged between the shaft spline and the dynamic damper. 2. Install the dynamic damper. ...

See also:

Back-up Lamp Switch Description
Back up lamp switch is pushed by the reverse lug sliding when select arm, and switches the back up lamp. ...

Rain Sensor Circuit Diagram
...

Positive Crankcase Ventilation (PCV) Valve: Removal
1. Disconnect the vapor hose (A) after removing the fixing clip. 2. Remove the PCV valve (B) after unfastening it. ...

Categories

Copyright www.kirmanual.com 2014-2026