Kia Rio: Fluid Replacement - Hydraulic System - Automatic Transaxle System - Kia Rio UB 2012-2019 Service ManualKia Rio: Fluid Replacement


     
ATF of 6 speed automatic transaxle doesnТt need to be replaced. If the vehicle is used severely in business or personal use, replace ATF every 60,000 miles.
Severe usage is defined as
Х
Driving in rough road (Bumpy, Gravel, Snowy, Unpaved road, etc)
Х
Driving in mountain road, ascent/descent
Х
Repetition of short distance driving
Х
More than 50% operation in heavy city traffic during hot weather above 32∞C(89.6∞F) .
Х
Police, Taxi, Commercial type operation or trailer towing, etc
1.
Remove the drain plug (A) and reinstall the drain plug after draining ATF totally.



Drain plug tightening torque:
34.3 ~ 44.1 N.m (3.5 ~ 4.5 kgf.m, 25.3 ~ 32.6 lb-ft)


     
The gasket of the drain plug use new one.
2.
Fill the oil about 5 liters through eyebolt.
3.
Check the oil level.
(Refer to "Hydraulic system (Fluid)" in this group)
Fluid Service Adjustment Procedure
Oil level Check    A check of ATF level is not normally required during scheduled services. If an oil leak is ...

Valve Body Description
The valve body is essential to automatic transaxle control and consists of various valves used to control the oil feed from the oil pump. Specifically, these valves consist of pressure regula ...

See also:

Rain Sensor Circuit Diagram
...

Component Location
1. Driver power window switch 2. Door lock switch 3. BCM (Body Control Module) 4. Front door lock actuator 5. Rear door lock actuator 6. Internal junction box ...

Explanation of scheduled maintenance items
Engine oil and filter The engine oil and filter should be changed at the intervals specified in the maintenance schedule. If the vehicle is being driven in severe conditions, more frequent oil an ...

Copyright © www.kirmanual.com 2014-2019