Kia Rio: Rear Wheel Alignment

When using a commercially available computerized wheel alignment equipment to inspect the rear wheel alignment, always position the vehicle on a level surface.

Prior to inspection, make sure that the rear suspension system is in normal operating condition and that the tires are inflated to the specified pressure.

Toe

B - A > 0: Toe in (+)

B - A ＜ 0: Toe out (-)

Toe is pre-set at the factory, so it does not need to be adjusted. If the toe is not within the standard value, replace or repair the damaged parts and then inspect again.

Toe:

Total : 0.5Â° (+0.4Â°/ -0.5Â°)

Individual :0.25Â°(+0.2Â°/ -0.25Â°)

Camber

Camber is pre-set at the factory, so it does not need to be adjusted. If the camber is not within the standard value, replace or repair the damaged parts and then inspect again.

Camber : -1.5Â°Â±0.5Â°

Front Wheel Alignment

When using a commercially available computerized wheel alignment equipment to inspect the front wheel alignment, always ...

Wheel Hub Nut Tightening Sequence

Tighten the hub nuts as follows. Tightening torque : 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) ...

Kia Rio: Rear Wheel Alignment

Front Wheel Alignment

Wheel Hub Nut Tightening Sequence

See also:

Categories