Kia Rio: SRS Control Module (SRSCM) Removal
| 1. |
Remove the ignition key from the vehicle.
|
| 2. |
Disconnect the battery negative cable and wait for at least three
minutes before beginning work.
|
| 3. |
Remove the floor console.
(Refer to the Body group - "Console")
|
| 4. |
Remove the rear heating joint duct (A).
|
| 5. |
Pull up the lock, of the SRSCM connector, the disconnect the connector
(A).
|
| 6. |
Remove the SRSCM mounting nuts (3EA) from the SRSCM, then remove
the SRSCM.
|
SRS Control Module (SRSCM) Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three
minutes before beginning ...
See also:
Starter: Description
The starting system includes the battery, starter, solenoid switch, ignition
switch, inhibitor switch (A/T), clutch pedal switch (M/T), ignition lock switch,
connection wires and the battery ...
Transmitter Inspection
1.
Check that the red light flickers when the door lock or unlock
button is pressed on the transmitter.
2.
Remove the battery and check vol ...
Compressor Removal
1.
If the compressor is marginally operable, run the engine at idle
speed, and let the air conditioning work for a few minutes, then shut
the engine off.
...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2026 Owners Manual
- Kia Rio YB 2017-2026 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2026