Kia Rio: Driver Airbag (DAB) Module and Clock Spring Inspection
| Driver Airbag (DAB) |
If any improper parts are found during the following inspection, replace
the airbag module with a new one.
Never attempt to measure the circuit resistance of the airbag
module (squib) even if you are using the specified tester. If the circuit
resistance is measured with a tester, accidental airbag deployment will
result in serious personal injury.
|
| 1. |
Check pad cover for dents, cracks or deformities.
|
| 2. |
Check the airbag module for denting, cracking or deformation.
|
| 3. |
Check hooks and connectors for damage, terminals for deformities,
and harness for binds.
|
| 4. |
Check airbag inflator case for dents, cracks or deformities.
|
| 5. |
Install the airbag module to the steering wheel to check for fit
or alignment with the wheel.
|
Clock Spring
| 1. |
If, as a result of the following checks, even one abnormal point
is discovered, replace the clock spring with a new one.
|
| 2. |
Check connectors and protective tube for damage, and terminals
for deformities.
|
Driver Airbag (DAB) Module and Clock Spring Removal
1.
Set the front tires straight-ahead before removing the steering
wheel.
...
Driver Airbag (DAB) Module and Clock Spring Installation
1.
Set the front tires straight-ahead before assembling the steering
wheel.
...
See also:
Smart key unit Removal
Smart key unit
[USA]
1.
Disconnect the negative(-) battery terminal.
2.
Remove the smart key unit (A) after disconnecting the c ...
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the RPS at idle and various engine
speed.
...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2025 Owners Manual
- Kia Rio YB 2017-2025 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2025