Kia Rio: Side Airbag (SAB) Module Installation

Be sure to install the harness wires so they will not pinch or interfere with other parts.

â€¢	Do not open the lid of the side airbag cover.

â€¢	Make sure that the airbag assembly cover is installed properly. Improper installation may prevent the proper deployment.

1.	Remove the ignition key from the vehicle.

2.	Disconnect the battery negative cable and wait for at least thirty seconds.

3.	Install the new seat back assembly. (Refer to the Body group - "Seat")

4.	Install the front seat assembly. (Refer to the Body group - "Seat")

5.	Recline and slide the front seat forward fully, make sure the harness wires are not pinched of interfere with other parts.

6.	Reconnect the battery negative cable.

After installing the side airbag (SAB), confirm proper system operation:

A.	Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Side Airbag (SAB) Module Removal

The side airbag cannot be disassembled from the seat back assembly, so replace the seat back assembly when replacing the ...

Curtain Airbag (CAB) Module Description

Curtain airbags are installed inside the headliner (LH and RH) and protect the driver and passenger from danger when side crash occurs. The SRSCM determines deployment of curtain airbag by us ...

Kia Rio: Side Airbag (SAB) Module Installation

Side Airbag (SAB) Module Removal

Curtain Airbag (CAB) Module Description

See also:

Categories