Kia Rio Manuals

Kia Rio: Removal - Brake Pedal - Brake System - Kia Rio UB 2012-2026 Service ManualKia Rio: Removal

1.
Turn ignition switch OFF.
2.
Remove the crash pad lower panel.
(Refer to the Body group - "Crash pad")
3.
Remove the shower duct (A).
4.
Disconnect the stop lamp switch connector (A).
5.
Remove the shift lock cable (B) after removing the snap pin and the clip.
6.
Remove the BCM.
(Refer to the Body Electrical group - "BCM")
7.
Remove the mounting bracket bolts (A).
Tightening torque:
9.8 ~ 14.7 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft)


8.
Remove the snap pin (A) and clevis pin (B).
9.
Remove the brake pedal member assembly mounting nuts (A) and then remove the brake pedal assembly.
Tightening torque:
16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 lb-ft)


Components
1. Brake pedal member assembly 2. Stop lamp switch 3. Pedal bushing 4. Return spring 5. Brake pedal 6. Brake pedal pad ...

Inspection
1. Check the bushing for wear. 2. Check the brake pedal for bending or twisting. 3. Check the brake pedal retur ...

See also:

Display settings
Press the key Select [Display] through TUNE knob or key Select menu through TUNE knob Mode Pop up [Mode Pop up] Changes / selection mode During On state, press the or key to d ...

Power Door Lock Switch Inspection
Driver Door Lock Switch Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the front door trim panel. (Refer to t ...

Side Impact Sensor (SIS) Description
Side Impact Sensor (SIS) system consists of two P-SIS which are installed at each center of the front door module (LH and RH) and two SIS which are installed at each center pillar nearby (LH ...

Categories

Copyright www.kirmanual.com 2014-2026