Kia Rio Manuals

Kia Rio: Adjustment - Brake Pedal - Brake System - Kia Rio UB 2012-2025 Service ManualKia Rio: Adjustment

Brake Pedal Height and Free Play
1.
Disconnect the stop lamp switch connector (A).
2.
Adjust the brake pedal height (A) as illustration below.
Pedal height (A): 174.2 mm (6.86 in)
Full stroke (C): 108 mm (4.25 in)


3.
Adjust the stop lamp switch clearance (B).
Stop lamp clearance (B):
1.0 ~ 2.0 mm (0.04 ~ 0.08 in)
4.
Connect the stop lamp switch connector.
Stop lamp switch clearance adjustment
If the gap between stop lamp switch and bracket is not 1.0 ~ 2.0mm(0.04~ 0.08in), conform to below.
1.
Disconnect the stop lamp switch connector (A).
2.
Pull the locking plate (A) as indicated by the arrow.
3.
Turn stop lamp switch 45° counterclockwise and remove it.
4.
Fix the brake pedal arm and insert fully the stop lamp switch as hiding contact part.
5.
After inserting, turn the stop switch (A) 45° clockwise, and then assemble locking plate (B) by pushing.
6.
Confirm the gap between stop lamp switch and bracket.
Stop lamp clearance:
1.0 ~ 2.0 mm (0.04~ 0.08 in.)


7.
Connect the stop lamp switch connector.
Installation
1. Installation is the reverse of removal.    • ...

Front Disc Brake
...

See also:

Transaxle Control Module (TCM) Inspection
TCM Problem Inspection Procedure 1. TEST TCM GROUND CIRCUIT: Measure resistance between TCM and chassis ground using the backside of TCM harness connector as TCM side c ...

Oil Pump Unit (OPU) Installation
1. Installation is the reverse of removal. ...

EBD(Electronic Brake-force Distribution) Operation
The Electronic Brake force Distribution (EBD) system as a sub-system of the ABS system is to control the maximum braking effectiveness by the rear wheels. It further utilizes the efficiency ...

Categories

Copyright www.kirmanual.com 2014-2025