Kia Rio Manuals

Kia Rio: Replacement - Rear Disc Brake - Brake System - Kia Rio UB 2012-2026 Service ManualKia Rio: Replacement

Rear Brake Pads
1.
Loosen the guide rod bolt (B) and then remove the rear caliper body (A).
Tightening torque:
21.6 ~ 31.4 N.m (2.2 ~ 3.2 kgf.m, 15.9 ~23.1 lb-ft)



     
•
Where necessary prevent the guide rods from rotating with an appropriate wrench.
•
Be careful not to damage the dust covers.
2.
Replace pad retainers (A) and brake pads (B) in the caliper carrier (C).



     
•
Clean the pad retainer surface at the caliper bracket.
•
Inspect the piston boots for damage and replace if necessary.
•
Check the smooth action of the guide rods, and their dust covers for damage.
Removal
1. Remove the rear wheel & tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) ...

Inspection
Rear Brake Disc Thickness Check 1. Check the brake pads for wear and fade. 2. Check the brake disc for damage and cracks. ...

See also:

System Block Diagram
Component Parts And Function Outline Component part Function Vehicle speed sensor Converts vehicle speed to pulse. ECM Receives signals fr ...

Mode Control Actuator Inspection
1. Turn the ignition switch OFF. 2. Disconnect the mode control actuator connector. 3. Verify that the mode con ...

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the rear seat (Refer to "Seat" in BD gro ...

Categories

Copyright www.kirmanual.com 2014-2026