Kia Rio Manuals

Kia Rio: Removal - Rear Drum Brake - Brake System - Kia Rio UB 2012-2026 Service ManualKia Rio: Removal


     
•
Frequent inhalation of brake pad dust, regardless of material composition, could be hazardous to your health.
•
Avoid breathing dust particles.
•
Never use an air hose or brush to clean brake assemblies.
1.
Release the parking brake.
2.
Remove the rear wheel & tire.
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
3.
Remove the rear brake drum (A).
4.
Remove the upper return spring (A).
5.
Remove the lower return spring (B).


6.
Remove the shoe hold springs (A) and shoe hold pins (B) and then remove brake shoe (C). Make sure not to damage the dust cover on the wheel cylinder.
7.
Remove the parking brake cable (A) and then remove brake shoe (B).
8.
Disconnect brake tubes (A) from the wheel cylinder (B).


9.
Remove the bolt (C) and the wheel cylinder (B) from the backing plate (D).
Components
1. Shoe hold down pin 2. Shoe adjuster 3. Upper return spring 4. Adjusting lever 5. Shoe 6. Adjusting spring 7. Lower return spring 8. Shoe hold spring ...

Installation
   • Do not spill brake fluid on the vehicle: it may damage the paint; if brake fluid doe ...

See also:

Photo Sensor (FATC only) Replacement
1. Disconnect the negative (-) battery terminal. 2. With a flat-head screwdriver, remove the photo sensor (A) from the center of defrost no ...

Component Location
1. DC/DC converter ...

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the manifold absolute pressure sensor connecto ...

Categories

Copyright www.kirmanual.com 2014-2026