Kia Rio Manuals

Kia Rio: ESC Control Module Removal - ESC(Electronic Stability Control) System - Brake System - Kia Rio UB 2012-2026 Service ManualKia Rio: ESC Control Module Removal

1.
Turn ignition switch OFF.
2.
Pull up the lock of the HECU connector (A), and then disconnect the connector.
3.
Disconnect the brake tubes from the HECU by unlocking the nuts counterclockwise with a spanner.
Tightening torque:
A : 12.7 ~ 16.7 N.m (1.3 ~ 1.7 kgf.m, 9.4 ~ 12.3 lb-ft)
B : 18.6 ~ 22.6 N.m (1.9 ~ 2.3 kgf.m, 13.7 ~ 16.6 lb-ft)


4.
Loosen the HECU bracket nuts (A), then remove HECU and bracket.
Tightening torque:
16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 lb-ft)



     
•
Never attempt to disassemble the HECU.
•
The HECU must be transported and stored in.
•
Never shock to the HECU.
5.
Remove the 3 bolts, and then remove the bracket from HECU.
Tightening torque:
11 ~ 14 N.m (1.1 ~ 1.4 kgf.m, 8.1 ~ 10.3 lb-ft)
ESC Control Module Components
1. Front - left tube 2. Rear - right tube 3. Rear - left tube 4. Front - right tube 5. MC2 6. MC1 7. ESC control module (HECU) 8. Damper 9. Bracket ...

ESC Control Module Installation
1. Installation is the reverse of removal. 2. Tighten the HECU mounting bolts and nuts to the specified torque. 3. ...

See also:

Overhead Console Lamp Installation
1. Install the overhead console lamp after connecting the sunroof switch connector and lamp connector. 2. Install the lens after tightening ...

Power Window Switch Inspection
Power Window Main Switch Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the front door trim panel. (Refer to ...

Removal
1. Remove the trunk trim in the trunk after removing the screws and clips. (Refer to the BD group - "Tailgate") 2. Remove ...

Categories

Copyright www.kirmanual.com 2014-2026