Kia Rio Manuals

Kia Rio: Console Replacement - Interior - Body (Interior and Exterior) - Kia Rio UB 2012-2026 Service ManualKia Rio: Console Replacement

Floor Console Replacement
[M/T]

     
•
A plastic trim tool is recommended, but if prying with a screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Put on gloves to protect your hands.
1.
Using a screwdriver or remover, remove the gear boots (A).
2.
Using a screwdriver or remover, remove the console upper cover (A).
3.
Using a screwdriver or remover, remove the parking brake cover (A).
4.
Remove the floor console pad (A).
5.
After loosening the mounting bolts and clips, then remove the floor console assembly (A).
6.
Installation is the reverse of removal.

     
•
Make sure the connector are connected in properly.
•
Replace any damage clips.
[A/T]

     
•
A plastic trim tool is recommended, but if prying with a screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Put on gloves to protect your hands.
1.
Using a screwdirver or remover, remove the gear boots (B) and gear knob (A).
2.
Using a screwdriver or remover, remove the console upper cover (A).
3.
Disconnect the connectors (A).
4.
Using a screwdriver or remover, remove the parking brake cover (A).
5.
Remove the floor console pad (A).
6.
After loosening the mounting bolts, screws, clips, then remove the floor console assembly (A).
7.
Installation is the reverse of removal.

     
•
Make sure the connectors are connected in properly.
•
Replace any damaged clips.
Console Components
1 . Floor console assembly 2 . Console upper cover [M/T] 3 . Console upper cover [A/T] 4. Potable ash tray 5 . Parking brake cover 6 . Floor console pad ...

Crash Pad Components
(1) 1 . Main crash pad assembly 2 . Crash pad side cover [LH] 3 . Crash pad side cover [RH] 4 . Fuse box cover 5 . Crash pad lower panel 6 . Knee bolster panel 7 . St ...

See also:

Component(1)
※ Installation order : A → B → C → D → E 1. Steering column shaft 2. Lighting switch 3. Wiper and washer switch 4. Screw 5. Steering angle ...

5Door Rear Body
Side outer panel rear corner Tail gate hinge mounting hole (Ø14) Tail gate hinge mounting hole (Ø1 ...

Rear Shock Absorber Replacement
1. Remove the rear wheel & tire. Tightening torque : 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) ...

Categories

Copyright www.kirmanual.com 2014-2026