Kia Rio: 35R Clutch Control Solenoid Valve(35R/C_VFS) Inspection - Automatic Transaxle Control System - Automatic Transaxle System - Kia Rio UB 2012-2026 Service ManualKia Rio: 35R Clutch Control Solenoid Valve(35R/C_VFS) Inspection

1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the resistance is within the specification.
35R Clutch Control Solenoid Valve(35R/C_VFS) Circuit Diagram
...

35R Clutch Control Solenoid Valve(35R/C_VFS) Removal
   Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the ...

See also:

Transaxle Control Module (TCM) Inspection
TCM Problem Inspection Procedure 1. TEST TCM GROUND CIRCUIT: Measure resistance between TCM and chassis ground using the backside of TCM harness connector as TCM side c ...

Input Speed Sensor Description
Input speed sensor (A) is a vital unit that measures the rate of rotation of the input shaft inside the transaxle and delivers the readings to the TCM. The sensor provides critical input data ...

Troubleshooting
Vehicle inspection SYMPTOM CHART Symptom Suspect Area Remedy (See page) Squeak or grunt-noise from the front suspension, occurs more in cold ambient t ...

Copyright © www.kirmanual.com 2014-2026