Kia Rio: Auto Light Switch Inspection

Operate the auto light switch, then check for continuity between terminals of multi-function switch connector.

Circuit Diagram

...

Auto Light Sensor Inspection

In the state of IGN1 ON, when multi function switch module detects auto light switch on, tail lamp relay output and head lamp low relay output are controlled according to auto light sensor ...

See also:

Installation
1. Installation is the reverse of removal. 2. After installation, bleed the brake system. (Refer to Brake system bleeding) ...

Overhead Console Lamp Installation
1. Install the overhead console lamp after connecting the sunroof switch connector and lamp connector. 2. Install the lens after tightening ...

Mode Control Actuator Replacement
1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad. (Refer to BD group - "Crash Pad") ...